Installation Guide

INDICATOR
LIGHT
Remote Control Functions (Fig.1)
Delay - Off
Blower Speed Decrease and Off
Blower Speed Increase and On
Light
Press (Delay) and (Light) together to Reset
Filter Alarm.
IMPORTANT:
Holding Delay for more then 3 seconds could
cause remote to lose link.
English
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERY TO THE INSTRUCTION.
FCC ID: QUS-BESMARTNEW
IC: 11613A-BESMARTNEW
• Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
• This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
LINKING PROCEDURE
- To link the remote control to the hood, you can
activate the LINKING procedure.
- This procedure is useful if there are two or
more products that can be controlled by means
of remote control for example, in apartments
with adjacent kitchens, showrooms, fairs, etc.
1 - Determine the hood control from list below.
2 - Press delay on the remote until LED
indicator light up.
3 - Complete the link within 3 seconds by
pressing the button indicated below Hood
control indicator will light up or an audible
beep to confirm the link.
ABC D
E
1234 123
SPEED
LIGHTING INTENSITY
CONTROL
Hood Control 1
LINK CONFIRM P1
Hood Control 2
LINK CONFIRM P5
Hood Control 3
LINK CONFIRM P2
Hood Control 5
Note: To complete link press and hold “A” until
hood beeps or light intensity 1 and 3 light up.
Hood Control 4
LINK CONFIRM P1
FIG. 1
L1
LED
RING