Getting Started / Instrument list

Pi t c H B. ra n G E
Sets the pitch bend range in semitones of the selec-
ted group or the entire instrument, depending on
the EDIT ALL button status.
Hi G H Pa S S / lO w Pa S S On/Of f Sw i t c H
Enables Low Pass or Hi Pass Filter.
Hi G H Pa S S S l i d E r
Sets the High Pass Filter Frequency of the selected
group or the entire instrument, depending on the
EDIT ALL button status.
lO w Pa S S S l i d E r
Sets the Low Pass Filter Frequency of the selected
group or the entire instrument, depending on the
EDIT ALL button status.
tu n E
Sets the tuning of the additional note. With the ar-
rows on the right side of the eld you can adjust the
tuning in semitones.
rE V E r B On/Of f Sw i t H
Enables the Convolution-Reverb effect.
rE V E r B lE V E l
Sets the output level of the Convolution Reverb
Effect. This effect concerns the whole instrument.
rE V E r B Sw i t c H
Opens The Reverb Editor.
Inside the opened Reverb Editor:
Pr E dE l a y
Sets the Pre Delay Time of the Convolution Reverb
Effect. This effect concerns the whole instrument.
Si z E
Sets the impulse response le size of the Convolu-
tion Reverb Effect. This effect concerns the whole
instrument.
dr O P d O w n li S t S
Let you easily load different reverb settings by
opening the lists or alternatively just by clicking
the forward/backward arrows.
Ed i t al l Bu t t O n
This button is as powerful as it is dangerous. Not
for your life or your studio – but for the settings of
your instruments.
If the Edit All button is enabled, all changes you
make are applied to all groups, keyswitches or
loops that are part of the instrument. That inclu-
des Time-and Beatmachine, lter, volume and tune
settings. No matter what group you have been wor-
king on before, the settings are applied to all parts
of the instrument.
If the Edit All button is disabled, the changes are
only applied to the currently selected group, loop
or phrase. In KEY-Instruments, this is the active
Keygroup, in the other instruments, the selected
group is the last played note or sound.
Effects from the effects- and the performance sec-
tion are always affecting the whole instrument and
are not affected by the Edit All button. And if you
really get stuck, you can always reload your inst-
rument.
EffEctS PaGE
This is the section where you can enable and adjust
effects for the whole instrument.
The effects are Compressor, Saturation, Equalizer,
Delay, Chorus and Phaser. With the new LED On/
Off switches you get an easy overview of the active
effects.
4