User manual

14
b. Press [RUNTIME] to enter the password. The display should read I (for password level 1). You may
now change parameters that require a user password. For password requirements, see the third column
of the parameter table in Section 303.
Note: If no keys are pressed for five minutes, the UPS password level goes back to level “0,” and
you must re-enter the user password.
3. Press [CANCEL] to return to the parameter number display (P-XX). Note that the [CANCEL] key lets you
switch between the parameter number and parameter value.
4. Use the [%LOAD] or the [VOUT] key to go to the parameter that you wish to change. Then press [CANCEL]
to display the parameter value.
5. Whenever a parameter value is displayed, use these keys to change the setting:
• Press [%LOAD] to increase the setting.
• Press [VOUT] to decrease the setting.
Note: In step 1, you entered the user password. If a parameter requires a higher password for changes,
the UPS will not let you change that parameter.
6. To enter the new value, press [RUNTIME]. The UPS beeps to confirm that the new value has been entered.
If you wish not to save a change that you have made, press [VLINE] and the value will remain at its
original setting.
7. If you wish to change additional parameters, repeat steps 3-6.
8. To escape parameter mode, press [VLINE] twice.
Table 3 explains what each of the keys does when a parameter number or parameter value is displayed.
Table 3: Parameter Mode Key Functions
303 Parameter Table
The parameter table, Table 4, explains many of the unit’s parameters. See Sections 301 and 302 for
information on displaying and changing parameters.
Note: Some parameters are not listed. These parameters are used only in special circumstances or are
intended to help qualified service personnel troubleshoot, adjust, and calibrate the UPS.
E
N
G
L
I
S
H
Enters the new parameter setting.This key has no function
when the parameter number
is displayed.
5
RUNTIME
Returns to the parameter number display without
saving any changes made to the parameter value.
Escapes parameter mode.ESCVLINE
Increases the parameter setting.Goes to the next parameter
number.
+%LOAD
Decreases the parameter setting.Goes back to the previous
parameter number.
—VOUT
Switches to the parameter number.Switches to the parameter
value.
#CANCEL
When a Parameter Value is DisplayedWhen a Parameter
Number is Displayed
Programming
Template Key Name
Key