Specifications

The Answer in Power Protection
SOLA 610 UPS Maintenance and Warranty
The TROUBLESHOOTING CHART covers most of the difficulties that
you may encounter under normal working conditions. If the UPS fails to
operate properly, please review the following checks before calling the
repair centre:
1. Is the UPS plugged into a correctly working outlet?
2. Is the line voltage within the rating specified?
3. Has the fuse or the circuit protector on the back panel tripped?
Please note the following information when you call for service:
1. Model number, Serial number.
2. Date of problem.
3. Full description of problem.
SOLA Customer Service Centre Locations are listed on the rear page.
5.3 Troubleshooting
Fuse or Circuit
Breaker
Troubleshooting Chart
Problem Possible Cause Action to Take
No Lights, No Alarm (UPS
not ON)
Rear panel fuse blown or
circuit protector tripped.
Replace fuse or reset
protector. Restart UPS
No incoming utility. Check input power.
No "AC Line" light, alarm
beeps every few seconds.
No incoming utility. Check input power.
Fuse blown or protector
tripped.
Replace fuse or reset
protector. If problem
remains, call for service.
"FAULT" LED lights, alarm
beeps continuously.
UPS failure. Call for service.
Backup time is less than
the rating.
Battery is not fully
charged. Dead battery.
Charger failure.
Recharge the battery for at
least 10 hours. Retest the
battery time. If problem
remains, call for service.
"LOAD LEVEL" LED's show
over 100%
Overloaded.
Remove the least critical
load.
Alarm beeps twice per
second.
Overloaded.
Remove the least critical
load.
15