Specifications

The Answer in Power Protection

SOLA 610 UPS Optional Features

You may wish to connect your UPS to a network management

system using SNMP. This will require the purchase of the

SNMP Adaptor card option (Part No. 0610-SNMP-00) which

will install in the communications slot on the rear of the UPS.

This device when plugged into the UPS communications slot

and connected to the network, can allow a network supervisor

to monitor and control the UPS via SNMP protocol under such

popular network management platforms like HP OpenView,

IBM NetView, etc.

The SNMP adaptor card has both 10BASE-2 and 10BASE-T

Ethernet interfaces built in and with autosensing capability, no

jumper or software settings are needed to select the Ethernet

medium. The SNMP adaptor has a DIP switch to set the I/P

address assignments and two (2) LED indicators show power

or network status plus error conditions.

In the SNMP Adaptor card option package you will find the

following items :-

•· One - SNMP adaptor card

• One - female - male connector cable for connecting the

SNMP adaptor card to a PC or terminal for configuration

• One - 3.5” DOS-formatted diskette containing the UPS

SNMP Agent MIB

• One - 3.5” tar- formatted diskette containing the UPS

SNMP Agent MIB

• One - User’s Configuration and Operations Manual

To install the SNMP adaptor card complete the following :-

1. Shutdown the UPS, remove your connected load and

remove the input line cord from the wall socket. If the

UPS is hard wired, isolate the UPS at the supply point

and make safe.

CAUTION : Even with the UPS switch off

dangerous voltages my still be present at the

UPS or its outlets.

2. Remove the communications slot cover on the rear of the

UPS. Slide the SNMP adaptor card option into the slot

and secure it with supplied screws.

3. Store the communications slot cover plate for recovery

should the SNMP adaptor card option be removed and

decommissioned in the future.

4. Follow the detailed set-up instructions which can be found

in the “User’s Configuration and Operation Manual” which

came with the SNMP Card option package.

4.5

Installation and Operation of the SNMP Card Option