User manual

Instructions for use:
Required tools: Pliers, sharp knife.
1. Using pliers, crush and remove zip ties from EZ-Pump inflation hose.
2. Pull inflation hose from strut and LE valve- hold the base of valve while removing hose.
3. Remove neoprene click-valve cover.
4. Remove click-valve. Retain for later use if in good condition.
5. Cut new inflation tube to appropriate length- measure using old hose.
6. Slide click-valve onto new tube.
7. Slide neoprene cover over click-valve.
8. Form 2 zip-ties into 2 rings.
9. Slide zip-tie over each end of inflation hose.
10. Press hose firmly down onto EZ-valve on strut and LE- tube must sit flush with valve.