User`s manual

DOCSIS 1.0 Cable Modem User Guide Rev. 3.0 19

LAN

(PC)

• Dark for no Ethernet carrier present or power off

• Solid for Ethernet carrier present

• Make sure your PC is ON and in working condition. Verify if your

network card is installed properly. Usually a light on the network card

indicates it’s working status. Consult with your Network card

Manufacturer or Best Data Technical support for help

(DATA)

• Dark for no user data going though the Cable

Modem or power off

• Flashing for user data going through the Cable

Modem

• If the above 3 LEDS are lit but you don’t see this LED flashing, please

verify that you have properly installed the TCP/IP drivers. Go back to the

installation section.

(TEST)

• Dark for initial self-test of the Cable Modem OK

or power off

• Flashing for initial self-test of the Cable Modem

in progress or software down, or loading of the

Cable Modem in progress

• Solid for self-test failure of the Cable Modem

• If the above 3 LEDS are normal but RX LED does not blink, be sure that

your TCP/IP drivers are properly installed and your Internet browser is open

and functioning. This indicates the absence of downstream data transfer.

Consult with your cable provider and Best Data Technical Support for help.