Quick Start Guide

Specications
• Temperature: 33~100° F (0.6~38° C)
• Pressure: 20-100 psi (140-689 kPa)
• Capacity: 300 gal (1137 L)
• Flow rate: 0.5 gpm (1.9 lpm)
Substance reduction
The system has been tested and certied by the NSF International according to NSF/ANSI Standards 42 and 53 for
the reduction of the substances listed below. The concentration of the indicated substances in water entering the
system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system,
as specied by NSF/ANSI Standards 42 and 53. While testing was performed under standard laboratory conditions,
actual performance may vary.
Performance data sheet
Certications
One-year limited warranty
Visit www.bestbuy.com/bestbuyessentials for details.
Contact Best Buy essentials
For customer service, call 866-597-8427 (U.S. and Canada)
www.bestbuy.com/bestbuyessentials
Best Buy essentials is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2021 Best Buy. All rights reserved.
Troubleshooting
My refrigerator is not dispensing
water
Make sure that the lter is securely
connected to the receiver. Do not use
tools to tighten the lter in place.
Make sure that the water line to the
refrigerator is turned on. The valve
must be completely open for the
refrigerator to receive water.
Make sure that the refrigerator door is
closed or the dispenser will not work.
My water dispenser is dripping
A few drops are normal. If the water is
dripping constantly, have a service
technician check your refrigerators
water valve.
My water is cloudy or contains black
carbon pieces
Cloudy water is caused by microscopic
air bubbles. Run two (7.6 L) to three
(11.3L) gallons of water from your
dispenser to clear the air bubbles out.
Black carbon pieces in the water are
normal and appear with all carbon
lters. Run two (7.6 L) to three (11.3L)
gallons of water through your dispenser
to remove loose carbon pieces.
My new lter is making noises or
sputtering
Noises and sputtering are caused by
trapped air pockets. Run two (7.6 L) to
three gallons (11.3 L) of water through
your dispenser to push the air out.
Reinstall the new lter as instructed
and make sure that the lter is securely
connected to the receiver. Do not use
tools to tighten the lter in place.
My water tastes bad
If you do not use your water dispenser
for more than four days, run two
gallons (7.6 L) of water through the
dispenser before using it.
Make sure that you replace your lter
every three to six months to prevent
bacteria growth.
System Model No.: EFF-6002S
Replacement Filter Cartridge Model No.: BE-WP508531
Tested and Certied by NSF International in Model EFF-6002S against
NSF/ANSI Standards 42 and 53 for the reduction of the claims specied
on the Performance Data Sheet.
REPLACEMENT
ELEMENT
V1 ENGLISH 21-0081
SUBSTANCE
Chlorine, taste, and
odor
Benzene
Carbofuran
Lead (pH 8.5)
Lead (pH 6.5)
Cyst
Endrin
Mercury (pH 8.5)
Mercury (pH 6.5)
INFLUENT AVERAGE
1.9 mg/L
15 ug/L
73 ug/L
140 ug/L
140 ug/L
120,000 oocysts/L
6 ug/L
6 ug/L
6 ug/L
NSF SPECIFIED CHALLENGE
CONCENTRATION
2.0 mg/L ± 10%
15 ug/L ± 10%
73 ug/L ± 10%
140 ug/L ± 10%
140 ug/L ± 10%
minimum 50000 oocysts/L
6 ug/L ± 10%
6 ug/L ± 10%
6 ug/L ± 10%
AVE. %
REDUCTION
95.7%
96.6%
98.4%
99.6%
99.6%
>99.99%
93.6%
92.3%
93.8%
MAX. PERMISSIBLE
PRODUCT WATER
CONCENTRATION
N/A
0.5 ug/L
40 ug/L
10 ug/L
10 ug/L
N/A
2 ug/L
2 ug/L
2 ug/L
NSF REDUCTION
REQUIREMENTS
≥50%
N/A
N/A
N/A
N/A
≥99.95%
N/A
N/A
N/A
NSF TEST
REPORT
J-00295502
J-00268283
J-00268284
J-00268279
J-00268280
J-00263594
J-00296278
J-00326152
J-00268282
AVERAGE PRODUCT
WATER
CONCENTRATION
0.082 mg/L
0.5 ug/L
2 ug/L
0.5 ug/L
0.5 ug/L
1 oocysts/L
0.3 ug/L
0.5 ug/L
0.3 ug/L