Quick Start Guide

Press and hold the LED status button for three seconds to
enter small charging current mode (<100 mA) to charge
small current charging devices such as a Bluetooth
earphone. Four LEDs blink one by one during this mode.
●○○○○●○○○○●○○○○●
Your battery shuts down after two hours automatically. To
exit this charging mode during the two hours, press and
hold the button for three seconds.
Charging your portable
battery
Fully charge your portable battery
before using it for the rst time.
Charging takes about six and a half
hours.
1 Plug the small end of the
included USB cable into your
battery’s USB IN port.
2 Plug the other end into a
standard USB port on your
computer, car charger, or wall
charger (not included). Your
portable battery automatically
begins charging and the LED
turns on.
Note: All four LEDs turn on when your
portable battery is fully charged.
Compatibility
• Compatible with most mobile
devices, including iPhones.
• Use with a standard USB-A to
Lightning cable for Apple devices
or a standard USB-A to USB-C
cable for Android devices.
Features
• 10,000 mAh capacity charges
smartphones, tablets, and more
• Slim design conveniently ts a
pocket or purse
• USB ports (18 W total) recharge
two devices at the same time
• QC 3.0 port for fast charging of
compatible devices
• LED power indicators show your
remaining battery level
Charging your devices
Note: You can charge two devices
simultaneously.
1 Plug the large end of your phone’s
charging USB cable into one of
your battery’s USB ports. (Cable
not included)
Note: For the best performance, connect
your device to the (QC 3.0) port for
faster charging (on compatible devices).
2 Plug the other end into your
device. Your portable battery
automatically begins charging
your device.
WARNING: Do not charge devices while
your portable battery is recharging.
Note: Use with a standard USB-A to
Lightning cable for Apple devices or a
standard USB-A to USB-C cable for
Android devices.
Package contents
• 10,000 mAh Portable Battery
• 1 ft. (.3 m) micro USB cable
• Quick Setup Guide
Specications
• Dimensions (H × W × D):
5.5 × 2.8 × 0.6 in.
(14 × 7 × 1.6 cm)
• Input: Micro USB 5 V/2 A
• Output:
USB A-1: 5 V/2.4 A
USB A-2: 5 V/3 A; 9 V/2 A;
12 V/1.5 A (QC 3.0)
• Total output: 18 W
• Built-in cell capacity:
10,000 mAh, 3.7 V (37 Wh)
• Power bank capacity:
6,000 mAh (5 V/2.4 A)
5,950 mAh (5 V/3 A)
3,100 mAh (9 V/2 A)
2,300 mAh (12 V/1.5 A)
Power bank capacity will be less than
built-in cell capacity. Performance will
vary based on settings and
environmental conditions, and will
decrease over time and with use.
Micro USB
USB A-1
LED status button
USB A-2
●●●● 4 LEDs = 75-100% power
○●●● 3 LEDs = 50-75% power
○○●● 2 LEDs = 25-50% power
○○○● 1 LED = 5-25% power
○○○ Blinking LED = < 5% power
○○○○ If none of the LEDs light, your
battery needs to be recharged
Before using your new product, please read
these instructions to prevent any damage.
10,000 mAh
Portable Battery
Quick Setup Guide
BE-MMB10K22K