User Manual
Table Of Contents
- Contents/Contenido
- ENGLISH
- SAFETY INFORMATION INSTRUCTIONS
- Features
- Tools needed
- Package contents
- Installation instructions
- STEP 1- Determine whether your TV has a flat, irregular, or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Attach the plastic covers to the wall plate
- STEP 4 - Option 1: Attach hardware to a flat back TV
- STEP 4 - Option 2: Attach hardware to an irregular or obstructed back TV
- STEP 5 - Determine wall-mount location
- STEP 6 - Option 1: Install on a wood stud wall
- STEP 6 - Option 2: Install on a solid concrete or concrete block wall
- STEP 7 - Mount your TV to the wall plate
- If you ever need to remove your TV from the wall plate
- ONE-YEAR LIMITED WARRANTY
- ESPAÑOL
- INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- Características
- Herramientas requeridas
- Contenido del paquete
- Instrucciones de instalación
- PASO 1 - Determine si su televisor tiene una parte posterior plana, irregular u obstruida.
- PASO 2 - Selección de los tornillos, arandelas y espaciadores
- PASO 3- Sujetado de las cubiertas de plástico a la placa para pared
- Paso 4 - Opción 1: Fije los accesorios a un televisor con parte posterior plana
- Paso 4 - Opción 2: Fijación de los accesorios a un televisor con parte posterior irregular u obstruida
- PASO 5: Determine la ubicación del montaje en pared
- PASO 6 - Opción 1: Instale en una pared con viga de madera
- PASO 6 - Opción 2: Instalación en una pared de concreto sólido o de bloques de concreto
- PASO 7 - Fijación del televisor a la placa para pared
- Si alguna vez necesita quitar su televisor de la placa para pared
- GARANTÍA LIMITADA DE UN AÑO
16
BE-MLFX
www.bestbuy.com/bestbuyessentials
STEP 6 - Option 1: Install on a wood stud wall
You’ll need
1 Locate the studs. Verify the centers of the studs with an edge-to-edge stud finder.
2 Align the wall plate (A) at the height you determined in the previous step, make
sure that it is level, then use a pencil to mark the lag bolt hole locations (4) on the
stud centers. Remove the wall plate (A).
3 Drill pilot holes to a depth of 2 in. (50 mm) using a 3/16 in. (5 mm) diameter drill bit.
Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm).
Edge-to edge stud
finder
P (4)
Pencil
Drill
3/16" wood drill bit
1/2" socket wrench
Level
O (4)
Wall plate (A)
Wood
stud
2 in. (50 mm)
3/16 in.
(5 mm)
- Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm).
- Minimum spacing between horizontal fasteners cannot be less than 16 in. (40 cm)