User Manual
Table Of Contents
- Contents
- ENGLISH
- IMPORTANT SAFETY INSTRUCTIONS
- Features
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attach the mounting hardware to a TV with a flat back
- STEP 3 - Option 2: Attach the mounting hardware to a TV with an irregular or obstructed back
- STEP 4 - Determine the wall-mount location
- STEP 5 - Option 1: Install on a wood stud* wall
- STEP 5 - Option 2: Install on a solid concrete or concrete block wall
- STEP 6 - Secure your TV to the wall plate
- STEP 7 - Manage cables
- STEP 8 - Adjust the mount arm and tilt angles
- ONE-YEAR LIMITED WARRANTY
- ESPAÑOL
- INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- Características
- Herramientas requeridas
- Contenido del paquete
- Instrucciones de instalación
- PASO 1 - Determine si su televisor tiene una parte posterior plana, irregular u obstruida
- PASO 2 - Selección de los tornillos, arandelas y espaciadores
- PASO 3 - Opción 1: Instalación de la ferretería de montaje para televisor con una parte posterior plana
- PASO 3 - Opción 2: Instalación de la tornillería de montaje en un televisor con la parte posterior irregular u obstruida
- PASO 4 - Determine la ubicación del montaje en pared
- PASO 5 - Opción 1: Instalación en una pared con viga de madera*
- PASO 5 - Opción 2: Instalación en una pared de concreto sólido o de bloques de concreto
- PASO 6 - Fije el televisor a la placa para pared
- PASO 7 - Organización de los cables
- PASO 8 - Ajuste el brazo de montaje y los ángulos de inclinación
- GARANTÍA LIMITADA DE UN AÑO
11
Large Full Motion Mount for 47" - 84" TVs / Soporte grande de movimiento completo para televisores de 47 a 84 pulg.
www.bestbuy.com/bestbuyessentials
STEP 5 - Option 1: Install on a wood stud* wall
You’ll need
1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2 Align the center of the wall plate template at the height (a + b) you determined in the previous step, make sure that the
template is level, then tape it to the wall.
3 Drill four pilot holes through the template to a depth of 2.4 in. (60 mm) using a 3/16 in. (5 mm) diameter drill bit, then
remove the template.
Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm).
Edge-to edge
stud finder
Drill
3/16 in. wood
drill bit
Magnetic removable bubble
level
Wall plate template
Tape
B1 (4)
B3 (4)
Wall mount
Socket wrench
Align the center of the
template with the height
mark (a+b) you made in
STEP 4.
Level
* Minimum wood stud size: common 2 × 4 in. (51 × 102 mm) nominal 11/2 × 31/2 in. (38 × 89 mm).
* Minimum horizontal spacing between fasteners cannot be less than 16 in. (406 mm).
2.4 in. (60 mm)
3/16 in. (5 mm)