Quick Start Guide

Package contents
• Refrigerator water lter
• Quick Setup Guide
Compatibility
Compatible with the following
branded lters:
LG®
LT800P, LT800PC, LT800PCS,
ADQ73613401, ADQ73613401-S,
ADQ73613402, ADQ73613402-S,
ADQ73613403, ADQ73613407,
ADQ32617801, ADQ32617703,
ADQ72910901,ADQ73613408,
ADQ75795104
Kenmore®
9490, 469490, 46-9490
Features
• NSF 42 and 53 certied to lter contaminants, including chlorine, cysts, lead,
mercury, carbofuran, benzene, and endrin
• Lasts up to six months or 200 gallons (757 L)
• Eliminates cloudiness for fresh, clear drinking water
Installing your water lter
• It is normal for black carbon particles to appear on the outside of your lter. This
happens when the lter is moved during shipping. It is safe, simply wipe them o.
1 Shut o the water supply, then turn o the water shuto valve on your
refrigerator.
2 Locate the lter holder in the back upper right-hand corner of the refrigerator. To
open the lter cover, push in where indicated and the cover will drop down.
3 Remove the old lter by slowly rotating it counter-clockwise. A small amount of
water may drip down.
Note: When you pull out the water lter, a little water may leak from the opening. This is
normal. To minimize the water leakage, keep the lter horizontal when you pull it out.
4 Insert the new lter into the water lter holder.
5 Slowly turn the new lter clockwise until it stops. The lter will click and lock into
place.
Note: The lter connectors are large to prevent leaks. You might have to twist the lter hard
to make sure that the connection is secure.
6 Close the lter cover.
7 Turn on the water supply and run water through the dispenser for about ve
minutes at 0.5 gpm (about 2.5 gallons or 9.5 L) to remove any trapped air and clear
the system.
CAUTION: This lter should not be used with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
8 Open the refrigerator door and make sure that no water leaks from the new lter.
Note: If leaks occur, repeat the installation steps. If leaks persist, discontinue use and call
customer service.
WARNING: To reduce the risk of property damage due to water leakage, this lter MUST be
installed in accordance with the manufacturer's specications and instructions. This lter unit
must be replaced every 200 gallons (757 L) or 6 months. Failure to follow instructions and
operating specications will void your warranty. Further, the manufacturer assumes no
responsibility or liability for damages arising out of misuse of the product.
Refrigerator
Filter
Quick Setup Guide
BE-LGLT800P531
Before using your new product, please read
these instructions to prevent any damage.
Resetting your change
lter indicator
• LG: Press and hold the reset button
for three seconds. If this doesn’t
work, see the documentation that
came with your refrigerator.
• Kenmore: The lter reset for
Kenmore refrigerators varies by
model. See the documentation that
came with your refrigerator.
Storage and maintenance
• Replace your lter every six months
or two hundred gallons (757 L) to
prevent bacteria and fungus growth
in your lter, supply lines, and
storage tank.
• Stored lters do not expire. Keep
your unused lters in a cool, dark,
and dry place until you need them.
• If you do not use your water
dispenser for more than four days,
run two gallons (7.6 L) of water
before using it to prevent bad
tasting water.