Installation & Assembly

Step 6 Set Wall Panels
Cut 2x4 From Opening
1. Nail wall panels together using 10d sinkers
(4) four per corner. Secure panels to floor.
Do not nail 2x4 to floor in door opening.
2. Cut 2x4 from door opening.
6. Install lx3-72" boards along each side of the door opening. Tack these boards temporarily
with a couple nails; you may want to move the trim later when you install the doors.
3. Install 1x4-75 -3/4" trim boards at the front corners. Install the trim flush with siding
on the sidewalls. Use 8d galv. nails, spaced 12" apart.
4. Cut a 1x4-8' trim board and install between the corner trim, flush with the top of the
wall plate.
5. Repeat steps to install trim at the rear of the building.
1x4-8' Trim Board
1x3-72" Trim Boards
1x4-75 -3/4" Trim Board
Siding Extends Above Frame
Siding Extends Below Trim