Installation & Assembly

measure from here
When measurements are given for a board
length, it is from the longest side.
Tongue Edge
LAP Edge
Always wear safety glasses when cutting or nailing!
Tool List
Hammer & Phillips Screwdriver
Framing Square & Level
Hand Saw
Power Drill/Screwdriver
Measuring Tape
2-6' Step Ladders
IMPORTANT INFORMATION ABOUT YOUR SHED KIT
Siding Information
Siding panels have grooves cut into the
face. To identify which edge we want you
to use, we will refer to the edge as either
the 'LAP' Edge or the Tongue Edge.
Use 8d galv. nails. Space nails 12" apart.
The siding is primed. You will need to apply
a finish coat using latex acrylic paint.
Thank you for purchasing our Danbury shed kit.
The floor size should measure 8'-0" wide by 11'-9". Do Not make the foundation larger than the
building size. The siding should project beyond the foundation for water to
expel properly from
the sidewalls.
If you have any questions about assembling the kit, call 800-245-1577. If you are calling after
normal business hours, call 724-866-HELP (4357) or email to [e-mail].
The material that is included in our kit is listed on the back page. The optional floor package, if
ordered
, will be supplied by a local supplier.
Our kit does not include the shingles, the quantity needed is listed on the back page. The siding is
primed. You will need to apply a finish coat using latex acrylic paint.
Some 2x4s and OSB are used in the shipping pallet. Unpack the pallet, then
unscrew the OSB sheet
and (4) four 2x4s. The bit for the screws is packed in the hardware bag. This material will be used
for tie plates installed in Step 7
. The OSB sheet will be used for roof sheathing in Step 9.
Stacking the boards, according to size, will make them easier to find when needed. Some boards
have colored ends. Do Not discard any material until your building is complete.
Before you begin construction obtain a building permit and check all pertinent building codes.
Thank you for your purchase.