Installation & Assembly

Plyclip
Install roof sheathing with 7d sinkers, space nails 12" apart. When installing
sheathing across the top, insert a plyclip into the roof sheathing between each
truss. The top row of sheathing will be about 1" below the ridge to allow for
optional ridge venting. See detail next page.
Step 13 Install 1x4 Fascia
1. Install 72" long 1x4 fascia trim over the
2x4 Truss Headers that were installed in
Step 11. Install 1x4 trim boards flush
with the bottom of the 2x4 and siding on
the front gable.
2. Cut a 74" long 1x4 to length and install
flush with the siding on the rear gable.
3. Repeat to install 1x4 fascia on the
opposite sidewall.
Step 14 Install Roof Sheathing
Detail 'B'
4' x 6'
1. Install the first 4x6 roof sheathing panel against the
back of the siding. Note: Using a straight edge install
the top edge of the roof sheathing flush with the face
of the 1x4 fascia. See Detail 'B'.
2. Install a 15" x 48" sheathing panel at the top.
1x4 Fascia Trim
Siding
Roof Sheathing
2x4 Truss
Header
Straight Edge
1x4 Fascia