Installation & Assembly

2. Repeat Steps 8 thru 10 to install
the opposite gable.
Step 9 Install 'Z' Flashing
Step 10 Install Roof Gable Siding
Step 11 Install 2x4 Truss Headers
1. Place a 72" long 2x4 on top of the siding on the front wall, it will butt against the siding on
the roof gable. Nails this 2x4 to the 2x4 tie plate with 10d sinkers.
2x4-6' Board
Roof Gable
Front Wall Siding
2. Gather a 2x4 removed from the pallet.
Cut to fit and install next tot he 2x4
installed above.
3. Repeat to install 2x4 on the opposite
back wall.
1. Install gable siding on the back gable using 6d
galv. nails spaced 12” apart along the top of the
gable frames. Use 8d galv. across the bottom. The
gable siding will extend 1/2" above the 2x4 frame
to receive the roof sheathing installed later.
‘Tongue’ edge
60" Long 'Z' Flashing
Roof Gable
End Wall Siding
Install (2) two 60” pieces of 'Z' flashing across
the top of the siding on the end wall siding.
Secure in place using 6d galv. nails spaced 12”
apart. The ends will be covered by corner trim.