Owners manual

72" Top Wall Plate

72" Bottom Wall Plate with saw cut

24"

23-1/4"

3. Square the wall frame. Select a 24" wide siding with the

'Tongue' edge. Install the cut edge flush the end of the wall

frame. Siding should extend 3/4" below bottom plate.

When the sidewalls are erected the saw cut in the 2x4 bottom plate needs to be

located at the front of the building. This will allow the doors to open properly when

installed in a later step. Follow the instructions below carefully.

4. Assemble another 6' wall frame with the saw cut on the right end.

5. Mark the frame with the 'F' where shown below.

Cut Edge

Tongue Edge

6. Square the wall frame. Select a 24" wide siding with the 'Tongue' edge.

Install the cut edge flush the end of the wall frame.

Cut Edge

Tongue

Edge

Step 5A Assemble 6' Long Sidewall Panels

1. Position 2x4-72" boards together (one 2x4 has a saw cut) and indicate with 'X' marks,

where the wall studs will be located.

2. Install 72" long wall studs between the wall plates. Mark the end of the wall with the letter 'F'.

Saw Cut

Here

Saw Cut

Here