Owners manual

Step 11 Install Rear Gable & Tie Plates
1. Install rear gable on the rear wall. The siding will
extend over the 1x4 trim. NOT behind the trim!
Nail bottom gable plate to the lower wall with 10d
sinkers. Nail bottom edge of siding to the trim with
7d galv. nails.
2. Starting at the front of the building, install a 48" long 2x4 as a tie plate, on top of the
sidewall panels. Use 10d sinkers.
3. Install (2) two 6' long 2x4 next. Cut the last one to fit.
4. Install 2x4s on the opposite sidewall the same way.
2x4-48" Tie Plate
2x4-72" CenterTie Plate
Gable Siding
1x4 Trim