Owners manual

IMPORTANT: Install rollers on the
inside track leg, not between the legs.
Inside Leg
Step 18 Install Doors
View From Inside
1. Locate the door that will be positioned on the right when facing the outside of the building.
This will be the door with the siding and trim board extending past the 2x4 frame, see detail
below. Hang this door first. Slide the rollers on the track as shown below.
If it is necessary to adjust the door height, loosen two screws that secure the carrier to the
door. Adjust door so the aluminum angle, on the bottom of the door, does not rub on the
treated threshold. Tighten the two screws.
Tip: Inserting a screw, shown below, will prevent the doors from falling through the opening
between the track, if the door is opened too far.
Trim & Siding
Extends Past Frame
2x4 Frame
Adjustment Screws
Screw Stop
2. Hang the other door. On this door, install a sliding
door latch, on the lower back of the door to secure
this door in place when closed. You will need to drill
a hole in the floor for the round shaft to drop into.
3. Install a metal plate to the bottom of the right door.
The angle end will hold the bottom in-line with the
left door when closed.
4. Install the door handles and door hasp on the outside
of the doors.
Sliding Bolt on the
back of left door
Door Track
End View
Space
Between
Legs
Track Leg