Owners manual

Step 11 Install Rear Gable & Tie Plates
1. Install rear gable on the rear wall. The siding will
extend over the 1x4 trim. NOT behind the trim!
Nail bottom gable plate to the lower wall with 10d
sinkers. Nail bottom edge of siding to the trim with
7d galv. nails.
2. Cut a 2x4-6' board in half. Starting at the front of the building, install a 36" long 2x4
as a tie plate, on top of the sidewall panels. Use 10d sinkers.
3. Cut one of the 2x4s from the pallet to 6' and install next.
4. Cut to fit and install the 36" long 2x4 cutoff to finish.
5. Install 2x4s on the opposite sidewall the same way.
2x4-36" Tie Plate
2x4-72" CenterTie Plate
Gable Siding
1x4 Trim