Instructions / Assembly

2. Install (2) two 3-7/8" x 71-1/2"
long primed door jamb material
on the sides of the door opening,
flush with the face of the siding.
3. Install 72-1/2" long 1x4 door
trim on each side of the door
opening flush with top of door
opening. Use 8d galv. nails
4. Install a 70" long 1x3 trim
centered across the top of the
door opening.
Roof Shingles
7 bdl. shingles & 6 pcs. drip edge
Metal Roof Panels
Rafter Length..................6' - 9".
Roof Length..................12' - 4".
Roof Pitch ........................ 9/12.
Finish Roof Covering
Step 20 Install Roofing — Not Supplied in Kit
If you are installing shingles, install metal roof edging around the perimeter of the roof area. Follow
the instructions on the shingle wrap. If you need more detailed instructions there are good publications
at book stores or 'youTube' videos on the web. If you are not installing shingles at this time, you
can purchase felt paper to protect the roof sheathing. Otherwise, check the manufacturer's instructions
if felt paper is necessary. Install the felt paper before you install the metal roof edge.
If you are installing metal roof panels, refer to the information in the box below when ordering.
Install the roof panels per the instructions provided by the manufacture.
Step 1 9 Install Door Jamb & Trim
1. Cut to fit a 3-7/8" wide primed door jamb material under the door header flush with the face
of the siding. Use 6d galv nails.
1x6 Fascia
1x6 Gable Trim
Felt Paper
Roof
Edge
Primed Door Jamb