Installation & Assembly

2. Install 52-7/8" long wall studs, between the wall plates, over the 'A', 'B' and 'X' marks. Use
10d sinkers. Nail wall frames together.
3. Disassemble the shipping pallet and remove (4) four 2x4. The screw bit is in the hardware bag.
4. Cut (1) one 77" long 2x4 into (2) two pieces 30" long. Install first piece flush with end of wall.
5. Install a 77" long 2x4 next. Finish with 2nd 30" long 2x4. Square wall frame.
6. Install (3) three full width x 60" siding panels. The
siding should extend 3-1/2" beyond the wall frame
on left, 2" above top and 3/4" below bottom plate.
LAP Edge
LAP Edge
A
A
B
B
X
X
X
X
X
X
X
X
X
X
X
X
Step 4 Assemble Back Wall
Siding Extends 3/4" Below Plate
1. Position (4) four 68-1/2" long 2x4s together and indicate with 'X' marks, where the wall
studs will be located. Mark the ends that will butt together with the letters 'A' and 'B'.
77" Tie Plate
68-1/2" Bottom Plate
A
B
Siding Extends 3-1/2"
Beyond Frame
Siding will extend 2"
above the top plate.
68-1/2" Wall Plate
68-1/2" Wall Plate
24"
19-3/4"
24"
23-1/4"
30" Tie Plate
30" Tie Plate