Installation & Assembly

Step 2 Assemble Roof Trusses
1x4 Block
1. Position one of the pre-built gable frames against the top edge of the end wall panels. Temporarily
nail 1x4 blocks to the floor along the edge of the gable frame and on the angle of wall. The
gable frame is not attached to wall in this step.
2. Remove the wall panels and the gable frame. Do not remove the 1x4 blocks. They will be
used in the next step to make sure the trusses are assembled identically.
3. Position a 69-1/2" long 2x4 and a 47-1/8" long 2x4s on the floor against the 1x4 blocks and
secure the 2x4s together with a wood gusset. Using (10) ten 6d common nails evenly spaced.
4. Turn truss over and apply wood gusset to the opposite side.
5. Assemble (4) four more trusses.
1x4 Block
Pre-built Gable Frame
2x4 - 47-1/8" Long
2x4 - 69-1/2" Long