Installation & Assembly

STOP! If you purchased the optional metal roofing go to the instructions
packaged in the roofing kit. Steps 10, 11 & 12 in this book are skipped.
Step 10 Install Soffit and Trim
2. Install (1) one 1x4x47-1/4" and (1) one 1x4x72" long gable trim, flush with the top of the roof
sheathing on each end wall. Use 8d galv. nails.
3. Install (2) two 77-1/2" long 1x3 trim on the front corners, flush with the siding on the sidewall.
4. Install the remaining (4) four 1x4 trim boards at the end wall corners flush with the 1x3 trim
on front and back walls.
77-1/2" Long 1x3 Trim
5. Install (2) two 1x3x72" boards along each side of the door opening, flush with the bottom edge
of the siding. Tack these boards with a couple nails; you may want to move the trim later when
you install the doors. Install a 1x3x55-1/4" board, that has angle cuts on both ends, across the
top of the side trim. About 3/4" of siding will hang below top trim.
1x4x47-1/4" Gable Trim
1x4x72" Gable Trim
1. Install 6-1/4" x 48" soffit panels under the
truss overhang. Use 6d galv. nails.
79-1/2" Long 1x4 Trim
58" Long 1x4 Trim