Installation

BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
9
Installing the lock
Installation Instructions for Electronic Stand-Alone Cylindrical Locks
13 Install through-bolts and
inside rose liner
1 Place the inside rose liner on the chassis, aligning the
holes in the rose liner with the holes prepared in the
door, as shown in Figure 13.
Caution: Make sure that the motor wire is pulled
toward the top of the fire plate and avoid routing
it over any surface that could damage the
sleeving or wire insulation.
2 Install the through-bolts through the rose liner and
door in the top and bottom holes.
Caution: Make sure that there is clearance for the
motor wire between the rose liner and the door.
3 Tighten the rose liner to the door and fire plate with
the through-bolts.
4 Install the hub washer over the rose liner.
14 Route wire harness and position
outside escutcheon
1 From the outside of the door, feed the motor
connector, battery connector, and Keypad EZ remote
unlock wires through the harness hole one at a time,
as shown in Figure 14.
Caution: When routing the connectors, make sure
the wire harness is not routed across any sharp
edges or over any surface that could damage its
sleeving or wire insulation.
2 On the inside of the door, insert the two counter sunk
mounting screws into the holes at the top and
bottom of the fire plate.
3 Tighten the mounting screws until the fire plate is
securely mounted to the door.
Figure 13 Installing the through-bolts and rose liner
(9K shown)
Inside of door
Motor wire
Rose liner
Hub
washer
Through-bolt
Figure 14 Feeding the wire harness connectors through
the harness hole (B.A.S.I.S. or NT500 Lock shown)
Motor connector
Outside escutcheon
Outside of door
H
a
r
n
e
s
s
h
o
l
e
Battery connector
Remote unlock
(Keypad EZ only)