Installation
Table Of Contents
- Contents
- Site survey
- Components checklist
- Special tools checklist
- Drill holes and mortise for latch face
- Optional: Keypad EZ Locks only: Prepare for remote unlock installation
- Install latch
- Optional: For 93KG, 93KBV and 93KZ only: Use drill jig to drill through-bolt holes
- Install strike box and strike plate
- Remove outside lever or knob
- Adjust for door thickness
- Install lock chassis and engage retractor in latch
- Optional: B.A.S.I.S. and NT500 Locks only: Remove backup battery tab
- Install the trim hole insert, bushing, and hub washer on outside of door
- Install fire plate
- Install through-bolts and inside rose liner
- Route wire harness and position outside escutcheon
- Route wires on fire plate
- Make motor connection
- Install bottom cover (inside escutcheon)
- Install battery holder
- Install inside and outside levers or knobs
- Install core and throw member
- Install top cover (inside escutcheon)
- Test lock
Installation Instructions for Electronic Stand-Alone Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
8
Installing the lock
11 Install the trim hole insert,
bushing, and hub washer on
outside of door
1 On the outside of the door, insert the trim hole insert
into the upper trim hole, as shown in Figure 11.
2 Insert the bushing into the harness hole.
3 Slide a hub washer over the chassis sleeve so it rests
on the hub.
12 Install fire plate
Position the fire plate on the inside of the door so
that the chassis fits through the square opening in
the fire plate, as shown in Figure 12.
Figure 11 Installing the outside trim hole insert,
bushing, and hub washer
Trim hole insert
Bushing
Hub washer
Hub
Outside of door
Figure 12 Installing the fire plate
Inside of door
Fire plate