Installation
Table Of Contents
- Contents
- Site survey
- Components checklist
- Special tools checklist
- Drill holes and mortise for latch face
- Optional: Keypad EZ Locks only: Prepare for remote unlock installation
- Install latch
- Optional: For 93KG, 93KBV and 93KZ only: Use drill jig to drill through-bolt holes
- Install strike box and strike plate
- Remove outside lever or knob
- Adjust for door thickness
- Install lock chassis and engage retractor in latch
- Optional: B.A.S.I.S. and NT500 Locks only: Remove backup battery tab
- Install the trim hole insert, bushing, and hub washer on outside of door
- Install fire plate
- Install through-bolts and inside rose liner
- Route wire harness and position outside escutcheon
- Route wires on fire plate
- Make motor connection
- Install bottom cover (inside escutcheon)
- Install battery holder
- Install inside and outside levers or knobs
- Install core and throw member
- Install top cover (inside escutcheon)
- Test lock
Installation Instructions for Electronic Stand-Alone Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
4
Preparing the door and door jamb
4 Install latch
1 Install the latch in the door.
Note: The latch tube prongs should be centered and
should project into the chassis hole.
2 Check that the door swings freely.
5 Optional: For 93KG, 93KBV and
93KZ only: Use drill jig to drill
through-bolt holes
1 Press the drill jig (KD303) onto the door, engaging it
with the latch tube prongs (see the close-up in
Figure 5). Make sure the front edge of the jig is
parallel with the door edge.
2 Drill the through-bolt holes (5/16″ diameter) halfway
into the door.
3 Turn over the drill jig and repeat steps 1 and 2 from
the opposite side of the door.
Note: Replace the drill jig after 10 door preparations.
Figure 4 Installing the latch in the door
Latch
Location of latch
tube prongs
Chassis hole
Inside of door
Figure 5 Installing the drill jig and drilling the
through-bolt holes
Latch
tube
prongs
Drill upper through-bolt hole.
Drill lower through-bolt hole.
Inside of door