Installation

Installation Instructions for Electronic Stand-Alone Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
3
Preparing the door and door jamb
2 Drill holes and mortise
for latch face
1 Drill the holes listed below:
■ upper and lower trim holes
◆ 5/8″ diameter
◆ through door
■ harness hole
◆ 3/4″ diameter
◆ through door
◆ location based on handing
■ motor wire hole
◆ 7/16″ diameter
◆ through door
◆ before drilling chassis hole
■ chassis hole
◆ 2 1/8″ diameter
◆ through door
◆ after drilling motor wire hole
■ latch hole
◆ 1″ diameter
◆ meets chassis hole
Note 1: To locate the center of a hole on the opposite
side of the door, drill a pilot hole completely through the
door.
Note 2: For holes through the door, it is best to drill
halfway from each side of the door to prevent the door
from splintering.
2 Mortise the edge of the door to fit the latch face.
3 Drill the holes for the screws used to install the latch.
3 Optional: Keypad EZ Locks only:
Prepare for remote unlock
installation
If you want to be able to operate the Keypad EZ Lock
remotely, that is from a momentary push-button
switch, see Installation Instructions for Keypad EZ
Remote Unlock (T80922) for complete instructions.
Figure 2 Drilling holes and mortising for the latch face
Latch hole
Upper trim
Harness
hole
Motor wire hole
Chassis hole
Lower trim
hole
Latch face
mortise
Inside of door