Installation

Installation Instructions for Electronic Stand-Alone Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
2
Preparing the door and door jamb
1 Position template and mark
drill points
Note: If the door is a fabricated hollow metal door,
determine whether it is properly reinforced to support
the lock. If door reinforcement is not adequate, consult
the door manufacturer for information on proper
reinforcement. For dimensions for preparing metal
doors, see the G01 and G02 Templates—Installation
Specifications for 83/93KG, 83/93KBV, 83/93KN and
83/93KZ Cylindrical Locks.
Note: If the door is a LH or RH door, mark the inside of
the door. If the door is a LHRB or RHRB door, mark the
outside of the door.
For uncut doors and frames
1 Measure and mark the horizontal centerline of the
lever (the centerline for the chassis hole) on the door
and door jamb. Mark the vertical centerline of the
door edge.
Note: The recommended height from the floor to the
centerline of the crossbore or chassis hole is 38″ .
2 Fold the G05 Template—Installation Template for
83/93KG, 83/93KBV, 83/93KN and 83/93KZ Cylindrical
Locks on the dashed line and carefully place it in
position on the high side of the door bevel.
Note: For steel frame applications, align the template’s
horizontal centerline for the latch with the horizontal
centerline of the frame’s strike preparation.
3 Tape the template to the door.
4 Center punch the necessary drill points. Refer to the
instructions on the template.
For doors with standard cylindrical preparation
1 Fold the G05 Template—Installation Template for
83/93KG, 83/93KBV, 83/93KN and 83/93KZ Cylindrical
Locks on the dashed line. Looking through the hole
from the opposite side of the door, align the
template so that you see the template outline of the
2 1/8″ diameter chassis hole.
2 Tape the template to the door.
3 Center punch the necessary drill points. Refer to the
instructions on the template.
Figure 5 Positioning the template
Installation template