Installation
Table Of Contents
- Contents
- Site survey
- Components checklist
- Special tools checklist
- Drill holes and mortise for latch face
- Optional: Keypad EZ Locks only: Prepare for remote unlock installation
- Install latch
- Optional: For 93KG, 93KBV and 93KZ only: Use drill jig to drill through-bolt holes
- Install strike box and strike plate
- Remove outside lever or knob
- Adjust for door thickness
- Install lock chassis and engage retractor in latch
- Optional: B.A.S.I.S. and NT500 Locks only: Remove backup battery tab
- Install the trim hole insert, bushing, and hub washer on outside of door
- Install fire plate
- Install through-bolts and inside rose liner
- Route wire harness and position outside escutcheon
- Route wires on fire plate
- Make motor connection
- Install bottom cover (inside escutcheon)
- Install battery holder
- Install inside and outside levers or knobs
- Install core and throw member
- Install top cover (inside escutcheon)
- Test lock
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
13
Completing the installation
Installation Instructions for Electronic Stand-Alone Cylindrical Locks
21 Install top cover
(inside escutcheon)
1 Position the top cover above the fire plate and slide it
down over the guide notches on the fire plate.
Caution: Make sure that the top cover does not
pinch any wires as you slide it over the fire plate.
2 Use two cover screws to secure the cover to the side
of the fire plate, as shown in Figure 21.
Note: Phillips Type 2 and T20 Torx options are available
for the cover mounting screws.
Figure 21 Installing the top cover
Top cover
Inside of door
Cover screws