Installation
Table Of Contents
- Contents
- Site survey
- Components checklist
- Special tools checklist
- Drill holes and mortise for latch face
- Optional: Keypad EZ Locks only: Prepare for remote unlock installation
- Install latch
- Optional: For 93KG, 93KBV and 93KZ only: Use drill jig to drill through-bolt holes
- Install strike box and strike plate
- Remove outside lever or knob
- Adjust for door thickness
- Install lock chassis and engage retractor in latch
- Optional: B.A.S.I.S. and NT500 Locks only: Remove backup battery tab
- Install the trim hole insert, bushing, and hub washer on outside of door
- Install fire plate
- Install through-bolts and inside rose liner
- Route wire harness and position outside escutcheon
- Route wires on fire plate
- Make motor connection
- Install bottom cover (inside escutcheon)
- Install battery holder
- Install inside and outside levers or knobs
- Install core and throw member
- Install top cover (inside escutcheon)
- Test lock
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
11
Installing the lock
Installation Instructions for Electronic Stand-Alone Cylindrical Locks
17 Install bottom cover
(inside escutcheon)
1 Making sure that the cover does not pinch the
wires, guide the bottom cover over the chassis onto
the fire plate.
2 Use two cover screws to secure the cover to the side
of the fire plate, as shown in Figure 17.
Note: Phillips Type 2 and T20 Torx options are available
for the cover mounting screws.
Caution: Dress all wires away from possible pinch
points before bottom cover is put in place.
18 Install battery holder
1 Position the battery wires against the fire plate
side wall, as shown in Figure 18.
2 Slide the battery pack behind the fire plate side tabs
until it rests on the bent battery holding tabs.
Caution: When routing the battery wires, make
sure the wires are not routed across any sharp
edges or over any surface that could damage
their sleeving or wire insulation.
3 Connect the battery pack to the battery connector
on the wire harness.
Caution: When connecting the battery pack,
make sure:
◆ there are no loose wire connections where the
wires are inserted into the connectors.
◆ the connectors are firmly mated.
Figure 17 Installing the bottom cover
Inside of door
Cover
screws
Bottom
cover
Inside of door
Battery holder
Battery wires
Figure 18 Installing the battery holder, 8-cell shown
Battery wires