Installation

BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
1
Planning the installation
Contents
These installation instructions describe how to install
your B.A.S.I.S.® G (83KB or 93KG), B.A.S.I.S. V (83KBV or
9.3KBV), NT500 (83KN or 93KN) or Keypad EZ (83KZ or
93KZ) Cylindrical Lock. Topics covered include:
Planning the installation.............................................................. 1
Preparing the door and door jamb............................................ 2
Installing the lock ........................................................................... 6
Completing the installation.......................................................12
Site survey
Use the following survey to record information about
the installation site. You need this information to
determine how to prepare the door for the lock.
Door information
Door handing and bevel:
❑ Left hand (LH)
❑ Left hand, reverse bevel (LHRB)
❑ Right hand (RH)
❑ Right hand, reverse bevel (RHRB)
Door thickness:
inches (1 3/4″ to 2 1/4″)
Environment information
Ambient temperature:
❑ Is within specifications. See the tables below.
This product meets the following Locked Door Outdoor
test requirements for ANSI/BHMA 156.25:
This product meets the following Full Indoor test
requirements for ANSI/BHMA 156.25:
Side of door Range
Inside +66°F to +74°F (+19°C to +23°C)
Outside –31°F to +151°F (–35°C to
+66°C)
Side of door Range
Inside and
outside
+32°F to +120°F (0°C to +49°C)
Components checklist
Use the following checklist to make sure that you have
the items necessary to install your Electronic
Stand-alone Cylindrical Lock.
Components provided in the box:
❑ Chassis with outside lever or knob and outside rose
liner assembly
❑ Top and bottom inside covers
❑ Fire plate
❑ Battery holder with batteries
❑ Inside rose liner
❑ Outside escutcheon assembly
❑ Inside lever or knob
❑ Throw member package
❑ Latch
❑ Hub washers
❑ Trim hole insert package
❑ Plastic bushing package
❑ Escutcheon screw package
❑ Strike package
❑ Bar code ID sticker (for your records)
❑ Installation template and instructions
Other components:
❑ Core
❑ Control key
❑ Temporary operator card
(B.A.S.I.S. and NT500 Locks only)
Special tools checklist
Use the following checklist to make sure that you have
the special tools necessary to install your Electronic
Stand-alone Cylindrical Lock.
❑ KD303 Drill jig
(for use with 93KG, 93KBV, or 93KZ only)
❑ T20 TORX® bit driver
❑ KD325 Strike plate locating pin
❑ KD315 Faceplate marking chisel
Installation Instructions for
Electronic Stand-Alone Cylindrical Locks