Service manual

Servicing Standard Mortise Case Parts
6–4 B.A.S.I.S. V Service Manual
The following diagram and table show which components need to be
turned over when changing the hand and bevel. See the section that
follows for instructions.
■ B represents the latchbolt and auxiliary bolt
■ H represents the hubs
■ C represents the cylinder clamp plate assembly.
Figure 6.3 Overview of changing the hand and bevel (FV function, LH case shown)
Outside hub
Inside hub
Latchbolt
Cylinder clamp plate
Auxiliary bolt
LH RH LHRB RHRB
LH
B/H/C B H/C
RH
B/H/C H/C B
LHRB
BH/C B/H/C
RHRB
H/C B B/H/C