Service manual

Servicing Standard Mortise Trim Parts
5–8 B.A.S.I.S. V Service Manual
3. Feed the wire harness connectors through the harness hole:
a. From the outside of the door, feed the upgrade cable connector
through the harness hole.
b. From the outside of the door, feed the motor connector, battery
connector, and sensor connectors through the harness hole.
Note: NV function locks do not have a sensor harness.
Caution
When routing the connectors, make sure the harnesses are not routed
across any sharp edges or over any surface that could damage their
sleeving or wire insulation.
4. Rest the outside escutcheon on the door by inserting the trim studs
into the trim holes.
Note: You can temporarily install the outside lever to hold the
outside escutcheon in place. See Reinstalling the levers
(page 5–2).
Figure 5.9 Feeding the wire harness connectors through the harness hole
Motor connector
Harness hole
Outside escutcheon
Outside of door
Sensor connectors
Battery connector
Upgrade connector