Service manual

Servicing Standard Mortise Trim Parts
5–6 B.A.S.I.S. V Service Manual
e. Remove the outside escutcheon from the door, feeding the
motor connector and sensor connectors out the harness hole.
Caution
When removing the outside escutcheon, make sure that the harnesses
are not rubbed across any sharp edges or over any surface that could
damage their sleeving or wire insulation.
Reinstalling the
inside and outside
escutcheons
1. Activate the backup battery:
If you are reinstalling the outside escutcheon, go to Step 2.
If you are installing a new outside escutcheon, perform these
steps:
a. Locate the backup battery tab on the inside of the outside
escutcheon.
b. Pull down on the tab and remove it from the outside escutcheon
to turn on the backup battery.
Caution
For the lock to operate properly, you must remove the backup battery
tab.
Caution
Do not connect the battery pack before you have removed the backup
battery tab. Doing so may cause the lock to malfunction.
Figure 5.7 Locating the backup battery tab
Outside escutcheon
Battery backup tab