Service manual

Contents
viii B.A.S.I.S. V Service Manual
Removing the dual validation reader assembly 9–25
Reinstalling the dual validation reader assembly 9–27
Removing the proximity reader assembly 9–28
Reinstalling the proximity reader assembly 9–29
SERVICING EXIT HARDWARE TRIM ESCUTCHEON PARTS 10–1
Servicing the mounting standoffs 10–2
Removing the mounting standoffs 10–2
Reinstalling the mounting standoffs 10–2
Servicing the escutcheon gasket 10–3
Removing the escutcheon gasket 10–3
Reinstalling the escutcheon gasket 10–3
Servicing the lift finger 10–4
Removing the lift finger 10–4
Reinstalling the lift finger 10–5
Servicing the mounting plate 10–6
Removing the mounting plate 10–6
Reinstalling the mounting plate 10–7
Servicing the lever return springs 10–8
Removing the lever return springs 10–8
Reinstalling the lever return springs 10–8
Servicing the lens covers 10–9
Removing the lens covers 10–9
Reinstalling the lens covers 10–9
Servicing the primary harness 10–9
Removing the primary harness 10–10
Reinstalling the primary harness 10–10
Servicing the control electronics boards 10–10
Removing the magnetic stripe control electronics board 10–10
Reinstalling the magnetic stripe control electronics board 10–11
Removing the smart card control electronics board 10–11
Reinstalling the smart card control electronics board 10–11
Removing the dual validation control electronics board 10–11
Reinstalling the dual validation control electronics board 10–12
Removing the proximity control electronics board 10–13
Reinstalling the proximity control electronics board 10–13
Servicing the reader assemblies 10–13
Removing the magnetic stripe reader assembly 10–13
Reinstalling the magnetic stripe reader assembly 10–14
Removing the smart card reader assembly 10–14
Reinstalling the smart card reader assembly 10–14
Removing the dual validation reader assembly 10–14
Reinstalling the dual validation reader assembly 10–15
Removing the proximity reader assembly 10–15
Reinstalling the proximity reader assembly 10–15