Service manual

Shared Standard and Exit Hardware Trim Parts
4–6 B.A.S.I.S. V Service Manual
Lens cover kit The Lens Cover Kit described in the table below is used for both
standard B.A.S.I.S. Locks and EX Series Exit Hardware Trim.
Cable and harness
kits for standard
B.A.S.I.S. Locks
The cable and harness kits described in the table below are used only
for standard B.A.S.I.S. Locks. For the Primary Harness Kit for EX Series
Exit Hardware Trim, see page 4–10.
Component
Kit name Part number
Lens cover with retaining ring Escutcheon gaskets Mounting plate screw Lift finger screw
Lens Cover Kit 1838580 4
†
10 2
†. Kit includes one escutcheon gasket for standard B.A.S.I.S. Locks and one escutcheon gasket for
EX Series Exit Hardware Trim.
Components
Kit name Part number
Primary harness Tape for mounting the sounder Sensor harness Conversion harness Upgrade cable Escutcheon gasket
Primary Harness Kit 1833686
■■ ■
Sensor Harness Kit 1833728
■■
Conversion Harness Kit 1833760
■■
Upgrade Cable Kit 1833801
■■