Service manual

Contents
B.A.S.I.S. V Service Manual vii
Servicing the cylinder 8–10
Removing the mortise cylinder 8–10
Reinstalling the mortise cylinder 8–10
Removing the rim cylinder for Precision Hardware installations 8–11
Reinstalling the rim cylinder for Precision Hardware installations 8–11
Removing the rim cylinder for Von Duprin installations 8–12
Reinstalling the rim cylinder for Von Duprin installations 8–12
Servicing the B.A.S.I.S. escutcheon 8–13
Removing the escutcheon 8–13
Reinstalling the escutcheon 8–14
SERVICING STANDARD OUTSIDE ESCUTCHEON PARTS 9–1
Servicing the escutcheon gasket 9–2
Removing the escutcheon gasket 9–2
Reinstalling the escutcheon gasket 9–2
Servicing the lens covers 9–3
Removing the lens covers 9–3
Reinstalling the lens covers 9–3
Servicing the harness clamp 9–4
Removing the harness clamp 9–4
Reinstalling the harness clamp 9–4
Servicing the upgrade cable 9–5
Removing the upgrade cable 9–5
Reinstalling the upgrade cable 9–5
Servicing the sensor harness 9–6
Removing the sensor harness 9–6
Reinstalling the sensor harness 9–6
Servicing the primary harness 9–7
Removing the primary harness 9–7
Reinstalling the primary harness 9–8
Servicing the control electronics boards 9–10
Removing the magnetic stripe control electronics board 9–10
Reinstalling the magnetic stripe control electronics board 9–11
Removing the smart card control electronics board 9–12
Reinstalling the smart card control electronics board 9–13
Removing the dual validation control electronics board 9–15
Reinstalling the dual validation control electronics board 9–15
Removing the proximity control electronics board 9–16
Reinstalling the proximity control electronics board 9–17
Servicing the reader assemblies 9–19
Removing the magnetic stripe reader assembly 9–19
Reinstalling the magnetic stripe reader assembly 9–21
Removing the smart card reader assembly 9–22
Reinstalling the smart card reader assembly 9–24