Service manual

Shared Standard and Exit Hardware Trim Parts
B.A.S.I.S. V Service Manual 4–3
2. Replace the reader:
To replace the magnetic stripe reader, see page 9–19 (for
standard B.A.S.I.S. Locks) or page 10–13 (for EX Series Exit
Hardware Trim).
To replace the smart card reader, see page 9–22 (for standard
B.A.S.I.S. Locks) or page 10–14 (for EX Series Exit Hardware
Trim).
To replace the proximity reader, see page 9–28 (for standard
B.A.S.I.S. Locks) or page 10–15 (for EX Series Exit Hardware
Trim).
3. Replace the control electronics board:
To replace the magnetic stripe control electronics board,
see page 9–10 (for standard B.A.S.I.S. Locks) or page 10–10 (for
EX Series Exit Hardware Trim).
To replace the smart card control electronics board,
see page 9–12 (for standard B.A.S.I.S. Locks) or page 10–11 (for
EX Series Exit Hardware Trim).
To replace the proximity control electronics board,
see page 9–16 (for standard B.A.S.I.S. Locks) or page 10–13 (for
EX Series Exit Hardware Trim).
4. For standard locks, reinstall the inside and outside escutcheons on
the door. For mortise lock instructions, see page 5–6. For cylindrical
lock instructions, see page 7–8.
For exit hardware trim, reinstall the escutcheon on the door. See
page 8–14.