Service manual

Installation Instructions for B.A.S.I.S. EX Series Exit Hardware Trim
BEST ACCESS SYSTEMS
Indianapolis, Indiana
7
Installation Instructions for B.A.S.I.S. EX Series Exit Hardware Trim
Installing the exit hardware and trim
9
Route wire harnesses and position
B.A.S.I.S. escutcheon
1 From the outside of the door, feed the com port and
battery connector through the battery bracket/
harness hole as shown in Figure 6.
Caution 1: When routing the connectors, make
sure the harnesses are not routed across any
sharp edges or over any surface that could
damage their sleeving or wire insulation.
Caution 2: Do not put too much strain on the wire
harness either by pulling too hard on it or by
dangling the escutcheon from it.
2 Rest the B.A.S.I.S. escutcheon on the door by inserting
the trim studs into the mounting holes.
Figure 6 Feeding the wire harness connectors through
the battery bracket/harness hole
Com port
B.A.S.I.S.
escutcheon
Outside of door
Battery
connector
Battery
bracket/
harness
hole