Service manual

Installation Instructions for B.A.S.I.S. Cylindrical Locks
BEST ACCESS SYSTEMS
Indianapolis, Indiana
Completing the installation
10
15 Install battery pack
1 Connect the battery pack to the battery connector on
the wire harness inside the battery compartment.
Note: The battery connection has 3 wires and 3 pins. The
wire colors are:
■ red with white stripe
■ white
■ black with white stripe.
Caution: When connecting the battery pack, make
sure:
■ there are no loose wire connections where the
wires are inserted into the connectors
■ the connectors are firmly mated.
2 Place the battery pack inside the battery compartment
so that the foam will face the battery compartment
door.
Caution: When routing the battery wires, make
sure the wires are not routed across any sharp
edges or over any surface that could damage their
sleeving or wire insulation.
16 Install inside and outside levers
Note: To use a core and throw member from a
manufacturer other than BEST with a B.A.S.I.S. Lock, see
the Installation Instructions for 9K Non-
interchangeable Cores & Throw Members (T56093).
Skip task 16 and task 17.
For the inside and outside levers
1 With the handle pointing toward the door hinges,
position a lever on the outside sleeve and push firmly
on the lever until it is seated. Repeat, placing the other
lever on the inside sleeve.
2 Tighten the escutcheon mounting screws.
3 Turn the levers to check that they operate smoothly.
Figure 15 Connecting the battery pack
Battery pack
Inside escutcheon
Figure 16 Installing the levers
Outside of door