Service manual

Installation Instructions for B.A.S.I.S. Cylindrical Locks
BEST ACCESS SYSTEMS
Indianapolis, Indiana
9
Installation Instructions for B.A.S.I.S. Cylindrical Locks
Installing the lock
13 Make motor connection
From the inside of the door, connect the motor
connector from the chassis to its mating connector on
the wire harness.
Note 1: The upgrade cable is used for reprogramming
the lock’s firmware without removing the lock from the
door.
This cable does not connect to a mating lock connector.
Note 2: The motor connection has 2 wires and 2 pins.
The wire colors are yellow and gray.
Caution: When making the motor connection,
make sure:
■ there are no loose wire connections where the
wires are inserted into the connectors
■ the connectors are firmly mated.
14 Secure escutcheons
1 Position the inside and outside escutcheons on the
door.
2 Making sure that the escutcheons do not pinch
the wires, secure the escutcheons to the door—but
do not tighten. Use the combination mounting screw
at the upper trim hole and the standard mounting
screw at the lower trim hole.
Figure 13 Making the motor connection
Inside of door
Motor connection
Upgrade cable
Figure 14 Securing the escutcheons
Combination
mounting screw
Standard
mounting screw
Inside of door
Inside escutcheon