Service manual

BEST ACCESS SYSTEMS
Indianapolis, Indiana
1
Planning the installation
Contents
These installation instructions describe how to install your
B.A.S.I.S.® G (93KG–95KG) or B.A.S.I.S. V (93KBV–95KBV)
Cylindrical Lock. The following topics are covered.
†
Planning the installation................................................1
Preparing the door and door jamb ................................2
Installing the lock............................................................ 6
Completing the installation..........................................10
Site survey
Use the following survey to record information about the
installation site. You need this information to determine
how to prepare the door for the lock.
Door information
Door handing and bevel:
❑ Left hand (LH)
❑ Left hand, reverse bevel (LHRB)
❑ Right hand (RH)
❑ Right hand, reverse bevel (RHRB)
Door thickness:
inches (1 3/4″ to 2 1/4″)
Environment information
Ambient temperature:
❑ Is within specifications. See the tables below.
This product meets the following Locked Door Outdoor
test requirements for ANSI/BHMA 156.25:
This product meets the following Full Indoor test
requirements for ANSI/BHMA 156.25:
† The Best Access Systems logo and B.A.S.I.S. are
registered trademarks of Best Lock Corporation.
Side of door Range
Inside +66°F to +74°F (+19°C to +23°C)
Outside –31°F to +151°F (–35°C to +66°C)
Side of door Range
Inside and outside +32°F to +120°F (0°C to +42°C)
Components checklist
Use the following checklist to make sure that you have the
items necessary to install your B.A.S.I.S. Cylindrical Lock.
Components provided in the box:
❑ Chassis with outside lever and outside rose liner
assembly
❑ Inside escutcheon assembly
❑ Battery compartment door
❑ Battery pack
❑ Inside rose liner
❑ Outside escutcheon assembly
❑ Inside lever
❑ Throw member package
❑ Latch
❑ Hub washers
❑ Trim hole insert package
❑ Plastic bushing package
❑ Escutcheon screw package
❑ Strike package
❑ Bar code ID sticker (for your records)
❑ Temporary operator card
❑ Installation template and instructions
Other components:
❑ Core
❑ Control key
Special tools checklist
Use the following checklist to make sure that you have the
special tools necessary to install your B.A.S.I.S. Cylindrical
Lock.
❑ KD303 Drill jig
❑ T15 TORX® bit driver
‡
❑ KD325 Strike plate locating pin
❑ KD315 Faceplate marking chisel
‡ TORX is a registered trademark of the Camcar
Division of Textron.
Installation Instructions for
B.A.S.I.S. Cylindrical Locks