Service manual

Installation Instructions for B.A.S.I.S. Mortise Locks
BEST ACCESS SYSTEMS
Indianapolis, Indiana
9
Installation Instructions for B.A.S.I.S. Mortise Locks
Installing the lock
13 Make motor and sensor connections
From the inside of the door, make the motor
connection, the key override sensor connection (EV
and FV functions)
†
, and the deadbolt sensor
connection (FV and LV functions).
Note 1: It is physically possible to connect the key
override sensor connector from the mortise case to the
battery connector from the wire harness. To avoid this
mistake, connect only the connectors with matching wire
colors.
Note 2: The upgrade cable is used for reprogramming
the lock’s firmware without removing the lock from the
door. This cable does not connect to a mating lock
connector.
Caution: When making the motor connection and
sensor connections, make sure:
■ there are no loose wire connections where the
wires are inserted into the connectors
■ the connectors are firmly mated.
† Key override sensing is optional for 35HG and
standard for 35HBV.
Wire connection Colors
No. of
wires
No. of
pins
Motor Yellow
Gray
22
Key override sensor Gray 2 3
Deadbolt sensor Blue 2 3
Figure 13 Making the motor connection and
sensor connections
Motor
connection
Key override
sensor connection
Inside of door
Deadbolt sensor
connection
Upgrade cable