Service manual

Troubleshooting
B.A.S.I.S. V Service Manual 12–5
8. For standard locks, press the escutcheon gasket into place so the
electronics board is covered.
For exit hardware trim, reinstall the following parts in the
escutcheon:
■ mounting plate (page 10–7)
■ lift finger (page 10–5)
■ escutcheon gasket (page 10–3)
■ mounting standoffs (page 10–2).
9. For standard locks, reinstall the inside and outside escutcheons on
the door. For mortise lock instructions, see page 5–6. For cylindrical
lock instructions, see page 7–8.
For exit hardware trim, reinstall the escutcheon on the door. See
page 8–14.