Service manual

Maintenance
11–20 B.A.S.I.S. V Service Manual
Clearing the
diagnostics code
The lock’s diagnostics code indicates firmware conditions, such as
firmware resets, that have occurred at the lock since the diagnostics
code was last cleared. For more information, see page 11–13.
To clear a lock’s diagnostics code, perform these steps:
1. If you are already viewing diagnostics information for the lock,
go to step 2.
If you are not viewing diagnostics information for the lock,
perform step 1 through step 7 on page 11–14.
2. From the B.A.S.I.S. Transport Diagnostics window on the PDA
(Figure 11.12 on page 11–13), tap Diagnostics, then Reset, then
Diagnostics Code.
A confirmation message appears asking, “Reset diagnostics code?”
3. Select OK.
The diagnostics code is reset to 0x0000.
4. When you have finished using diagnostics features, perform step 8
through step 10 on page 11–17.