Service manual

Maintenance
B.A.S.I.S. V Service Manual 11–19
Unlocking a door
temporarily
You can use the PDA to unlock a door for the default duration
programmed for a lock. This feature is useful when you need to access
the inside of the door to replace the lock’s batteries or perform other
maintenance for the lock.
To unlock a door temporarily, perform these steps:
1. If you are already viewing diagnostics information for the lock,
go to step 2.
If you are not viewing diagnostics information for the lock,
perform step 1 through step 7 on page 11–14.
2. From the B.A.S.I.S. Transport Diagnostics window on the PDA
(Figure 11.12 on page 11–13), tap Diagnostics, then Unlock Once.
A confirmation message appears asking, “Unlock once?”
3. Select OK.
The lock unlocks for the default duration programmed for the lock,
letting you open the door.
4. When you have finished using diagnostics features, perform step 8
through step 10 on page 11–17.
Resetting the use
count
Every B.A.S.I.S. Lock keeps a count of times access is granted to a card
or PIN since the use count was last reset. You can use this count to
track how often a lock is used during a selected time frame.
To reset the use count for a lock, perform these steps:
1. If you are already viewing diagnostics information for the lock,
go to step 2.
If you are not viewing diagnostics information for the lock,
perform step 1 through step 7 on page 11–14.
2. From the B.A.S.I.S. Transport Diagnostics window on the PDA
(Figure 11.12 on page 11–13), tap Diagnostics, then Reset, then Use
Count.
A confirmation message appears asking, “Reset use count?”
3. Select OK.
The lock’s use count is reset to 0.
4. When you have finished using diagnostics features, perform step 8
through step 10 on page 11–17.