Service manual

Maintenance
B.A.S.I.S. V Service Manual 11–9
Reinstalling the
battery pack for
exit hardware trim
Note: Replacement battery packs are shipped with foam attached, but
foam is not needed for EX Series Exit Hardware Trim. Remove and
discard the foam before installing the battery pack.
1. Connect the battery pack to the battery connector on the wire
harness as shown in Figure 11.8.
Note: The battery connector has 3 wires and 3 pins. The wire colors
are:
■ red with white stripe
■ white
■ black with white stripe.
Caution
When connecting the battery pack, make sure there are no loose wire
connections where the wires are inserted into the connectors and the
connectors are firmly mated.
2. Place the battery pack in the holder inside the battery bracket and
dress the wire harness inside the bracket.
Caution
Make sure you do not damage the sleeving on the battery pack.
Doing so may cause the batteries to be drained.
3. If reinstalling with a surface rod device, dress the wire harness
inside the bracket to the left of the rod so that the harness will not
interfere with the movement of the rods.
We recommend that you loosely coil the harness and use a cable tie
to secure the coil. To avoid damaging the harness, do not put any
sharp bends in it or flex it close to the connectors.
Caution
Failure to dress the wire harness away from the rod could damage
the wire harness, causing the lock’s electronics to not work properly.
4. Making sure that the battery cover does not pinch any wires, place
the cover over the bracket.
5. Use a T15 TORX bit driver to secure the battery compartment cover
with the security screws. Tighten firmly. See Figure 11.7.