Service manual

Maintenance
11–8 B.A.S.I.S. V Service Manual
Removing the
battery pack for
exit hardware trim
1. Use a T15 TORX driver to remove the security screws from the
battery cover. See Figure 11.7.
2. Remove the battery cover from the battery bracket.
3. Remove the battery pack from the holder inside the battery bracket.
See Figure 11.8.
Note: You might need to cut a cable tie if one was used to dress the
wire harness inside the battery bracket.
4. Disconnect the battery pack from the battery connector on the wire
harness.
Figure 11.7 Removing and reinstalling the battery cover on the battery bracket
Security
screws
Inside of door
Figure 11.8 Removing and reinstalling the battery pack
Battery pack
Battery holder
(inside bracket)
Battery connector