Service manual

Maintenance
11–4 B.A.S.I.S. V Service Manual
REPLACING OR UPGRADING THE BATTERY PACK
To replace the four-cell battery pack for a standard B.A.S.I.S. Lock or for
EX Series Exit Hardware Trim, obtain part number B60726.
An eight-cell battery pack also is available for use with standard
B.A.S.I.S. Locks. To replace the eight-cell battery pack in a standard
lock, obtain part number B62101. An upgrade kit is available to upgrade
a standard lock with a four-cell battery pack (and brass escutcheons) to
an eight-cell battery pack. See page 4–5.
Removing the
battery pack for a
standard lock
1. Use a T15 TORX bit driver to remove the security screw from the
battery door. See Figure 11.3.
2. Open the battery door and remove it from the escutcheon.
3. Remove the battery pack from the battery compartment.
4. Disconnect the battery pack from the battery connector on the wire
harness. See Figure 11.4.
Figure 11.3 Removing the battery door (four-cell door shown)
Security screw
Tabs